Create a lovely and functional lined zippered bag in about fifteen minutes, using just a zipper and some fabric. The bag has French seams inside, so it's got that designer finish, and no fraying edges!
Step 1
Choose your fabric and your zipper. The colors can be whatever you want them to be! Also, your thread should complement your colors, as your top thread is going to show on part of the project.
Step 2
Cut four identical pieces of fabric. Here, I've cut them 5" x 7", but you can cut them whatever size you like, as long as your zipper is longer than the width of the bag you want.
Step 3
Take two of the pieces, and fold them in half wrong sides together. Now I have two pieces that are 2.5" x 7" each. Press. (Pressing here is NOT optional.)
Dry fit
Line up the folded edges against the teeth of the zipper. This step will get you excited, as it is what the bag is going to look like! YAY! :-)
Step 4
Put your zipper foot on your machine. Line up the folded edge of one of the pieces of fabric right against the teeth of the zipper, and line the zipper teeth up with the notch in the zipper foot. Stitch as close to the teeth as you can.
Voila!
Doesn't it look pretty? Now we're going to do the same thing again for the other side...
Step 5
Line 'em all up again, and stitch down this side, too.
See? I told you it would work.
And it looks just like it did when you dry fit it. Only with stitching.
The back...
...looks like this. (I used variegated thread in the bobbin, for no particular reason other than it was close to my hand -- this is why the stitching looks all color-changey.)
Step 6
Make your fabric sandwich. Take the two remaining large pieces of fabric and place them wrong sides together. Then put the zipper piece on top of that, so you have a stack. Then square them nicely, so the edges all line up.
Step 7
Starting at this exact point (zipper is closed, zipper pull is on the right, start your needle *just below* the zipper's teeth), stitch very close to the edge of the fabric, all the way around the bag.
This is going to be a scant (teeny) seam, which you're going to catch inside the next seam. TRUST me here. :-) Yes, the pouch is right-side-out when you're stitching it. No, that may not SEEM right, but it is. :-)
Step 7, continued
Continue all the way around the pouch...
Step 7, continued again
...until you get back to the zipper. Finish stitching *just before* you get to the zipper teeth. Do NOT stitch over the zipper on this side, where the pull is (you did stitch over the teeth on the opposite side, because you were supposed to).
Step 8
Trim the seams, so there are only a few threads beyond your seam. Don't leave more than 1/8" of seam allowance. The braver you are, the closer you can cut it. :-)
Step 9
This one is very important, and you will be quite upset if you forget to do it...OPEN THE ZIPPER so that it's an inch or so inside the border of the bag, and THEN, with your cruddy scissors, cut off the end of the zipper. (Cut the dangly end on the other side, too, if you didn't already when you were trimming the seams.)
Tacked together
This is what you've got right now. Looks gnarly...so we've got to finish those seams.
Step 10
Turn the bag inside out, and press. OK, the pressing is sort of optional here, but it'll make your life a lot easier if you press the seams a little bit.
Step 11
With the zipper mostly closed (open only enough that you'll be able to slide the zipper pull down later so you can turn the thing right side out), stitch about 3/16" from the edge, all the way around the bag. This catches the raw edges inside the seam, and seals them inside.
Step 12
Cut the corners diagonally across, close to the stitching (this is a bias cut, so it won't ravel). This will reduce the bulk when you turn the bag right-side out, and you'll never see the cut edges, because they'll be smooshed up in the corners.
Step 13
Turn the bag right-side out, and using an eyelet punch (or a dull pencil, or a not-too-pointy chopstick), push out the corners so they're sharp.
Done!
Now you've got a lovely finished bag! Or pouch. Or whatever. Use it to hold money, or Pokemon cards, or a pair of underpants, or tampons, or an iPod, or whatever!
If you'd like a stiffer pouch, fuse interfacing to the wrong side of each of the pieces before you start sewing.
If you have an embroidery machine, stitch a design or someone's name or initials on it before sewing. Or cut out a cute applique and fuse/stitch it to the pieces before you sew anything.
Or you can do some decorative stitching down the side of the zipper teeth. Or topstitch around the entire pouch on the outside, for a designer look! Or whatever!
























0 comment:
Post a Comment