Washable kraft paper;
Cotton fabric for lining;
Decorative element for decoration.
Pattern is shown on 2 sheets. Scale 1: 1, if you print on A4 sheet.
Cut out the pattern. Since one of the parts does not fit on one sheet of A4, we glue it together from two parts. Pattern of the main part is ready.
In all, there will be 3 parts from the craft. We cut out without allowances on seams.
For a lining, from a cotton fabric, there will be one detail. We cut it out with the allowances on the seams of 1 cm.
The allowances are ironed, except for the uppermost edge.
We fasten the clips with the main part of the craft and the lining, sew on the contour of the purse.
The seam starts at a distance of 1 cm from the top edge of the pad, runs along the entire circumference and ends 1 cm to the end of the lining edge.
Now take a small detail from the craft, the purse valve
Using glue, glue it to the main part, with an overlap on the lining.
Sew the valve and the main part. The seam is only on the outer upper edge.
Now we take the third detail from the craft - this part will divide the purse inside into the compartments.
We transfer the self-disappearing chalk to the part the line along which this inner part will be sewn to the main part. We combine it with the same line on the main part.
We fix it with clamps. Stitching. Do not forget to fix the beginning and end of the line.
We transfer the other lines from the pattern to the main part
We form folds along these lines. All folds are done by yourself
Install the buttons. The places on which the buttons are to be set are shown on the pattern in circles.
On the lower part of the main part we install two identical parts from two buttons. As shown in the photo
On the valve of the outer and inner parts we install other identical parts from the two buttons.
Now we begin the final assembly of the purse. We connect the internal valve and the external part.
We make 4 small seams. One at each connection
We add a decorative element at will, the purse is ready!